If you have a unique discount code, please enter it below and click the send button and you will be able continue downloading.It came with a USB dongle so I can use the laser with CoreLaser.
Corellaser 2013.02 Windows 10 Version 1083I have installed the Corel 10 and I am using Windows 10 Version 1083 When I click on the Cut or Engrave button I get an error Floating point division by zero I click OK and it goes back to Corel I have uninstalled both Corel 10 and CorelLaser and then re-installed.No change I dug up an old laptop and installed it on it and works fine.
By clicking the Agree button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy. More infomations about the cookies and further configurations Agree. Corellaser 2013.02 Update Of WindowsCorellaser 2013.02 Drivers To BeThis is due to a update of Windows called the anniversary update, with this windows denies unsigned drivers to be installed. ![]() But i would suggest you go with K40 Whisperer software instead. ![]() There was a list Controller Boards Known to Work with K40 Whisperer. Here are the numbers I found on my USB connection board: BE112096 and 9C249923.
0 Comments
Leave a Reply. |